How to Replace Your Garage Door Weather Stripping

How to Replace Your Garage Door Weather Stripping

Want to prevent water from seeping through your garage door? Hoping to keep heat, cold, and insects out as well? If so, you better ensure that your garage door weather stripping is intact.

But what if it isn’t? How do you replace the garage door bottom seal? We discuss that in detail below, showing you exactly how to facilitate weather-stripping garage door repair.

Measure the Existing Weather Stripping

You’ll start by measuring the existing weather stripping. This will be done to determine how much weather stripping you’ll need during the replacement. If you currently have 80 inches of weather stripping, you’ll need 80 inches during the replacement.

Remove the Existing Weather Stripping

Next, you’ll remove the existing weather stripping. This is done by either prying loose the metal cover or unscrewing the existing screws. Once you’ve done this, you can slide out the old stripping.

A good amount of debris is bound to be left where the weather stripping was located. Be sure to clean this before moving on to the next step.

Install New Weather Stripping

Now, it’s time to install the new weather stripping. Begin with the stripping at the top of the garage door.

Measure off a piece of weather stripping and trim it to match the former part of the weather stripping. Then, set it against the bracket and attach it with either nails or screws (depending on the specifics of your garage door).

Next, you’ll want to do the same but with the side weather stripping. Measure these so that they overlap with the top weather stripping. Then, attach them to the bracket with either nails or screws.

The overlapping section needs to create a tight seal. If the seal isn’t closed, there’s a potential for water to leak through it. That said, you’ll want to trim off excess stripping so that it’s aesthetically pleasing.

Test the Garage Door

Finish the process by testing the garage door. Open it and close it a few times, all while keeping an eye on the behavior of the new weather stripping.

If the weather stripping stays in place and maintains a tight seal, it’s good to go. However, if it needs to be altered in some way if it’s moving or loose.

Call your local garage door installation company if further assistance is needed. They’ll help you with any repairs that might be required.

Need Help Replacing Garage Door Weather Stripping?

We’ve shown you how to replace garage door weather stripping. But maybe you’re not confident in your ability to replace it alone. If not, you should utilize pro garage door services.

If you’re looking for a home garage door repair in Waukegan, IL, look no further than Premier Door Corp. We’ve repaired the weather stripping on countless garage doors throughout Waukegan. We’ll have your garage door operating like new again in no time.

Contact us today to get the process started!